Use the Gateway's touch sensitive surface to navigate the menu. Scroll to the bottom of this page if your Gateway has a joystick.
Power on the device.
Unlock the touchpad by tapping MENU three times.
Navigate the menu by tapping an arrow on the touchpad in the appropriate direction.
Save a selection by tapping the center square.
Lock the touchpad by tapping EXIT.
Note: The touchpad automatically locks after 10 seconds of inactivity.
Caution: Never unplug the Gateway without selecting the shutdown function first.
The Gateway must be connected to a functional network through a router to obtain an IP address. Connection to a PC may work for IP address configuration but not in cases due to PC configurations.
Once connected to a network the Gateway will display the network connection status on the display. The display should indicate "private net" or "internet" to indicate proper connectivity with a valid network.
Network connection codes are listed below:
Network Status Messages:
No network = connection failed
No cable = no cable in Ethernet port
No service = cable connected but not assigning service
No primary = network, but not on Ethernet
Private net = network without internet access
Internet = network with internet access
To use DHCP addressing (Gateway obtains a DHCP address from the network) select DHCP addressing (default) or turn off DHCP if using a static IP address.
To assign an IP address: Make sure DHCP is turned off, enter the IP address, netmask and gateway addresses.
A temporary IP address can be assigned and modified once you have access to the Gateway using the Gateway console.
If you have a Version 4 Gateway with a joystick, use the joystick to navigate the menu; push the joystick to enter a selection.
Uploading ....
